User Tools

Site Tools


robocore:hardware:edison_install

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
robocore:hardware:edison_install [2017/03/07 19:25]
zielmicha ↷ Page moved from hardware:edison_install to robocore:hardware:edison_install
robocore:hardware:edison_install [2017/03/13 15:56] (current)
66.249.79.73 ↷ Links adapted because of a move operation
Line 13: Line 13:
 Be careful - there is a very, very small electronic component close to one of holes on the Edison board. It is easy to damage it using screwdriver or other tools. Be careful - there is a very, very small electronic component close to one of holes on the Edison board. It is easy to damage it using screwdriver or other tools.
  
-{{:​hardware:​fragile.png?​nolink&​600|}}+{{robocore:​hardware:​fragile.png?​nolink&​600|}}
  
 Intel Edison must be installed directly to RoboCORE board, within the "​Wireless module"​ border: Intel Edison must be installed directly to RoboCORE board, within the "​Wireless module"​ border:
  
-{{:​hardware:​edison_before.jpg?​nolink&​600|}}+{{robocore:​hardware:​edison_before.jpg?​nolink&​600|}}
  
 When assembling an Intel® Edison module, handle the Intel® Edison module by the PCB edges. Avoid holding or exerting pressure to the shields. To mate the Intel® Edison board to the RoboCORE board, apply pressure directly above the connector. When assembling an Intel® Edison module, handle the Intel® Edison module by the PCB edges. Avoid holding or exerting pressure to the shields. To mate the Intel® Edison board to the RoboCORE board, apply pressure directly above the connector.
Line 26: Line 26:
 Just after you insert the Edison module to the RoboCORE, it shall be fastened to the main RoboCORE board with 2 screws. Otherwise the connector can be easily damaged. See the picture below and follow the steps. Screws are included in each RoboCORE kit. Just after you insert the Edison module to the RoboCORE, it shall be fastened to the main RoboCORE board with 2 screws. Otherwise the connector can be easily damaged. See the picture below and follow the steps. Screws are included in each RoboCORE kit.
  
-{{:​hardware:​edison_assembly.png?​nolink|}}+{{robocore:​hardware:​edison_assembly.png?​nolink|}}
  
   - Slip the spacer under one of holes   - Slip the spacer under one of holes
Line 40: Line 40:
 If you need to remove Intel Edison from RoboCORE, just unscrew the bolts and take out the Edison, the only thing to remember is shown below: If you need to remove Intel Edison from RoboCORE, just unscrew the bolts and take out the Edison, the only thing to remember is shown below:
  
-{{:​hardware:​edison_disassembly.png?​nolink&​600|}}+{{robocore:​hardware:​edison_disassembly.png?​nolink&​600|}}
robocore/hardware/edison_install.txt · Last modified: 2017/03/13 15:56 by 66.249.79.73